Table of Contents
Advertisement
SETTING UP
Read and follow these instructions before using your Steriliser.
THIS IS AN ATTENDED APPLIANCE. Do not leave
unattended during use, unplug after each use (risk of fire if an
unattended appliance is left operating).
Never remove the Lid while the Steriliser is operating (Power Indicator Light is illuminated).
This will cause a failure to sterilise. Please wait 5 minutes for the Steriliser to cool before
removing the Lid. Warning: Hot water and steam may cause serious injury and
burns; keep hands away from hot surfaces and steam vents. Risk of scalding.
Before first use, wash the Upper and Lower Racks and the Lid with warm soapy water and
rinse thoroughly. Do not submerge the Base, Power Cord or Plug as there is a risk of electric
shock and permanent damage to the appliance.
1
TER
Register your product at
Dualit.com this will only take
60 seconds; you will need
the product model and
serial number which is on
the rating label on the base
of the product.
2
3
Position the Steriliser on
Ensure that the Steriliser is
a flat surface away from
placed on a heat resistant
sources of heat. Place the
work surface. Do not
Steriliser as close to the
operate on a tray. Do not
wall socket as possible.
let the cord hang over the
Do not store or use
edge of work surfaces or
the Steriliser in an
touch hot surfaces.
appliance garage or
under cupboards,
close to curtains or
flammable material as
the Steriliser will emit
steam from the Steam
Vents in the Lid.
Do not cover vents,
covering vents causes
risk of fire.
08
USING YOUR STERILISER
Before first use or after a long period of no use, fill and then
operate your Steriliser empty with no bottles on a Sterilise function
(Steps 1-15 below).
It is important that all bottles, teats and accessories are empty,
separated and that they are thoroughly cleaned using soap suds and rinsed in fresh water
before placing in the Steriliser for sterilisation.
Warning: The Steriliser is only suitable for high temperature-resistant bottles
and items that can withstand a temperature of 100°C.
2
1
Clean and rinse bottles,
Pour exactly 90ml of fresh tap water into the Water Recess.
dummies and teats before
Do not exceed the max marker. You can use demineralised
sterilising.
water if you want to reduce the number of times you need to
descale.
3
After filling your Steriliser with 90ml of water,
place the Lower Rack into position. Ensure
Lower Rack is positioned correctly with logo
facing forward. Warning: The appliance
will not sterilise if Lower Rack is
incorrectly positioned.
Warning: Only operate with
90ml of water and do not over
fill. Ensure water is not spilled
or poured into the Air Vent
area. Never use less than 90ml
of water as sterilisation will
not complete, risk of bacterial
or viral contamination.
Tip - You can use a baby bottle
as a measuring device or weigh
90g of water.
4
Position baby bottles on the Lower Rack facing
downwards with the necks over the locators.
Place the bottle lids over the bases of the bottles.
Notes: The Steriliser can accommodate a
maximum of 6 bottles at a time.
09
Advertisement
Table of Contents
