Related Manuals for PolyVision Boundri
Summary of Contents for PolyVision Boundri
- Page 1 Boundri ™ Installation Guide Guidelines for installing your new Boundri privacy screens Doc # 100128 | Rev D | Page 1 of 10...
-
Page 2: Safety Requirements
Maximum tabletop thickness = 1.25” or 34 mm Minimum tabletop thickness = 0.25” or 6 mm Note: Clamps include inlays required for Panel Thickness Inlay Set Up Boundri panels. Additional inlays provided should clamps be used for alternative 10 mm - 9 mm 3,00 mm panels. -
Page 3: Product Configurations
Product Configurations Privacy | Back Mount Side Divider | Top Mount Page: 5 Page: 7 Privacy | Top Mount Privacy | Modesty Page: 6 Page: 8 Doc # 100128 | Rev D | Page 3 of 10... -
Page 4: Materials Provided
Materials Provided Note: Parts are not drown to scale. Inlay spacers Allen wrench Bottom cover Hole cover Table clamp screw Panel clamp screw Clamp base Table clamp / cap cover Panel clamp Doc # 100128 | Rev D | Page 4 of 10... - Page 5 Privacy | Back Mount Read all assembly directions before beginning installation. Use all panel clamps for the required positions. Step 1 Step 2 Turn the clamp screw to be tight with the Attach first part of clamp to mount. table surface. Step 3 Step 4 Do not tighten fully to support for easier...
- Page 6 Privacy | Top Mount Read all assembly directions before beginning installation. Use all panel clamps for the required positions. Step 1 Step 2 Turn the clamp screw to be tight with the Attach first part of clamp to mount. table surface. Step 3 Step 4 Do not tighten fully to support for easier...
- Page 7 Side Divider | Top Mount Read all assembly directions before beginning installation. Use all panel clamps for the required positions. Step 1 Step 2 Turn the clamp screw to be tight with the Attach first part of clamp to both mounts. table surface.
- Page 8 Privacy | Modesty Read all assembly directions before beginning installation. Use all panel clamps for the required positions. This setup can only be used with the following sizes: 18” x 24”, 18” x 36”, 24” x 24”, 24” x 36” or 385 mm x 585 mm, 385 mm x 785 mm, 585 mm x 585 mm, 585 mm x 785 mm Step 1...
- Page 9 PolyVision warrants that our panels, under normal atmospheric conditions and when sealed from moisture, will not delaminate from the substrate or warp for a period of 10 years. PolyVision warrants that our Mobile products, when used under normal conditions, will perform as intended for a period of 10 years.
- Page 10 E info@polyvision.com E APACsupport@polyvision.com ©2020 PolyVision Corporation. All rights reserved. Trademarks used herein are the property of PolyVision Corporation or of their respective owner. PolyVision Corporation reserves the right to make changes in product design, construction or detail, and to discontinue any product or material without notice.
Need help?
Do you have a question about the Boundri and is the answer not in the manual?
Questions and answers