Rompa 18907 Instructions For Use

CONTENTS
Each fan is supplied in its own plastic bag.

TO CHANGE THE BATTERIES

1. The battery compartment is at the bottom of the handle. Slide the bottom plastic plate of
the handle out (no tools required). Pull gently in the direction of the arrow.
2. Replace the used batteries with new batteries of the same specification: 2 x AA batteries.
When inserting batteries, bear in mind the following to avoid battery leakage:
•
Install the batteries as indicated, observing the polarity +/- (shown on the bottom
plate)
•
Do not mix old and new batteries
•
Do not mix alkaline, standard (carbon zinc) or rechargeable (nickel-cadmium)
batteries
•
Remove weak or dead batteries
•
Remove batteries if the product will be out of use for long periods
•
Do not attempt to charge non-rechargeable batteries
•
Do not short circuit the supply terminals
•
Do not attempt to dispose of batteries by burning them
•
If using rechargeable batteries, remove them from the product before recharging
(if removable)

TO USE

1. Slide the small switch at the top of the handle to switch on and activate the lights and fan.
2. Remember to switch off after use to preserve the batteries.
3. This product is especially effective in a darkened environment.
CARE & MAINTENANCE
This product cannot be repaired. Change the batteries as soon as operation becomes erratic.
Do not strike against anyone or anything. Take care not to drop to avoid damage.

SAFETY

Always supervise the use of this product. For three years and over.

SPECIFICATION

Size: approximately 11cm
LIGHT UP MINI FAN – SET OF 4, 18907
Colours may vary
LIGHT UP MINI FAN – SET OF 4, 18907, KH 2.07
Copyright ROMPA® Ltd