Advertisement
6
Connect the wireless transceiver communication cable to the COM
Port on automation control system circuit board
WARNING Switch OFF the main power to the Load Center
before making any connections.
1.
Switch OFF the AC power to the enclosure at the main house panel
circuit breaker.
2.
Unlatch the front door latch and open the front door. Remove the two
retaining screws from the High-Voltage Cover Panel and remove the
panel.
3.
Loosen the two retaining screws securing from the top edge of the
Outdoor Control Panel. Fold down the Outdoor Control Panel to
access the circuit board sockets connectors for the electrical
connections. Remove the panel from the enclosure (see illustration
below).
4.
Route the four conductor transceiver connection cable into the lower
plastic grommet, up through the low voltage raceway to the system
circuit board.
Outdoor
Control Panel
IntelliTouch
®
SCREENLOGIC
INTERFACE Wireless Connection Kit Installation Guide
Outdoor
Control Panel
retaining
screw (x2)
Retaining
screws
Latch
Inside Low
raceway
HIGH -VOLTAGE
FRONT COVER
PANEL
®
or EasyTouch
®
Control System Load Center
voltage
Grommet
(under side of
Load Center
Outdoor
transceiver
communication
cable
(connect to
COM port)
Advertisement
