Electrolytic Capacitors - Pacific Antenna Easy Receiver kit Manual

Electrolytic Capacitors

Now insert and solder the electrolytic capacitors. These capacitors are polarized. The positive hole is marked on
the circuit board with a + symbol. The negative lead of the capacitor is also marked with a black bar on the side of
the capacitor. This lead should go in the pad away from the + marking.
□ C15 10uF
□ C18 10uF
□ C19 10uF
□ C17 100uF
C21 100uF
o
Remaining Parts
□ L1 3.3uH
□ L2 3.3uH
□ L3 3.3uH
□ D2 1N5234 234B (glass body) DIODE
□ D1 1N5401 1N5401 (Large Black) DIODE
□ D3 1N5817 1N5817 DIODE
□ IC2 LM386N Audio Power Amplifier, 8 pin Ic"
□ IC1 NE602A NE602, 8 pin IC
□ C6 50pF brown trimmer capacitor,
Note: C6 has a flat and round side. It should be installed so that the flat side is oriented toward C5
The last parts to install are the potentiometers. The A10K and B10K identification marks are on the back of
the pots and are a bit difficult to read. Use lots of light. The pot marked A10K is the 10K Audio Pot. The
pot marked B10K is the Linear Pot.
□ R5 A10K Green Potentiometer, Horizontal, Audio
□ R2 B10K Green Potentiometer, Horizontal, Linear
EZRX 20170527
10uF ELECTROLYTIC CAPACITOR 25V+
10uF ELECTROLYTIC CAPACITOR 25V+
10uF ELECTROLYTIC CAPACITOR 25V+
100uF ELECTROLYTIC CAPACITOR 25V+
100uF ELECTROLYTIC CAPACITOR 25V+
org-org-gold-silver INDUCTOR, molded
org-org-gold-silver INDUCTOR, molded
org-org-gold-silver INDUCTOR, molded
6