Table of Contents
Advertisement
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6 ml.
3 ml is the factory default setting.
If spots appear on crockery and
glassware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
- Decrease the rinse aid dosage.
Using for the first time
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the button in and, while
holding it in, switch the dishwasher
on using the button.
Keep the button pressed in for at
least 4 seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the programme selection
button 3 times.
The top left programme indicator light
will flash rapidly 3 times at intervals.
The dosage set will appear in the
display after .
will start flashing in the display.
Setting 3 is set.
Use the button to select the
required setting.
The setting increases each time you
press the button. When the highest
value is reached, the setting starts
again from the beginning.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
29
Hide quick links:
Advertisement
Table of Contents
