Table of Contents
Advertisement
Chapter 3. Installing the Transducer Assemblies
3.9 Connecting an XAMP (cont.)
6. Connect the right angle male BNC plug to the exposed BNC cable from the cable gland assembly, as shown in
Figure 19 below.
7. Connect the female BNC plug of the XAMP to the male BNC transducer head as shown in Figure 20 below:
56
Figure 19: Connecting BNC Plug to the Cable
Figure 20: Female Plug to Male BNC Head
T5 Flare Gas Transducer Installation Guide
Advertisement
Table of Contents
