Page 1
SC112N-AC SERENE Four Glass Sided Chiller Type: HSC112NA from SKOPE...
Page 2
E-mail: enquiry@skope.co.nz Website: www.skope.co.nz Trademark Infringement The SERENE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...
SERENE SC112N-AC Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for future reference. When the appliance is used by or near young children or infirm persons, close supervision is necessary, especially to ensure children do not play with it.
SERENE SC112N-AC Positioning the Chiller Climate Class The chiller is designed to operate within a climate class 3 environment (25°C @ 60% RH). Location Select a suitable location for the chiller away from direct sunlight and heat sources e.g. radiators, baseboard heaters, cooking appliances etc.
SERENE SC112N-AC Operation Automatic Start-Up After the chiller has been positioned in a suitable place, plug it in and check the following activity. Item Activity Condenser fan The condenser fan starts immediately and can be heard. Evaporator fan The evaporator fan will start after a few seconds. To verify, check that the fan light is flashing on the electronic controller.
SERENE SC112N-AC Electronic Controller Introduction The electronic controller controls and displays the chiller temperature and signals temperature alarms. It uses temperature probes and a door switch to collect data and runs the chiller accordingly. The electronic controller automatically switches the chiller between ‘Day’ and ‘Night’ modes depending on chiller usage.
SERENE SC112N-AC Controller The electronic controller will automatically switch the chiller between ‘Day’ Operation and ‘Night’ modes depending on usage. If the front door (electronic controller side) is not opened for four hours, the chiller will automatically enter ‘Night’ mode and the sign and interior lights will switch off. To manually switch the chiller between ‘Day’...
SERENE SC112N-AC Maintenance Cleaning Many commercially available cleaning products contain solvents that may damage the plastic components of the chiller and cause them to crack. Do not use abrasive or corrosive cleaners or boiling water. CAUTION Isolate the chiller from the power supply before cleaning.
SERENE SC112N-AC Troubleshooting For problems with the chiller refer to the following table. Problem Possible Cause Suggestions • Chiller not operating. • Loss of power supply. • Check mains power supply. • Sign and/or Interior • Electronic controller • Switch the light on while lights not on.
Page 11
SKOPE Industries Limited NEW ZEALAND CONTACT Head Office PO Box 1091, Christchurch New Zealand Freephone: 0800 947 5673 Fax: (03) 983 3896 E-mail: enquiry@skope.co.nz Website: www.skope.co.nz AUSTRALIAN CONTACT ABN 73 374 418 306 PO Box 7543, Baulkham Hills B.C. NSW 2153, Australia Freephone: 1800 121 535 Fax: 1800 121 533 E-mail: enquiry@skope.com.au...
Need help?
Do you have a question about the SC112N-AC and is the answer not in the manual?
Questions and answers