Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Serene SC112G
Summary of Contents for Serene SC112G
- Page 1 SC112G SERENE Four Glass Sided Chiller Type: HSC112A/Z089 from SKOPE...
- Page 2 E-mail: enquiry@skope.co.nz Website: www.skope.co.nz Trademark Infringement The SERENE trademark on this product is infringed if the owner, for the time being, does any of the following: • Applies the trade mark to the product after their state, condition, get-up or packaging has been altered in any manner •...
-
Page 3: Table Of Contents
Troubleshooting......... 11 SERENE SC112G... -
Page 4: Installation
SERENE SC112G Installation Safety First Always observe safety precautions when using any electrical appliance. Read these instructions carefully and retain them for future reference. When the appliance is used by or near young children or infirm persons, close supervision is necessary, especially to ensure children do not play with it. -
Page 5: Positioning The Chiller
SERENE SC112G Positioning the Chiller Climate Class The chiller is designed to operate within a climate class 3 environment (25°C @ 60% RH). Location Select a suitable location for the chiller away from direct sunlight and heat sources e.g. radiators, baseboard heaters, cooking appliances etc. -
Page 6: Operation
SERENE SC112G Operation Automatic Start-Up After the chiller has been positioned in a suitable place, plug it in and check the following activity. Item Activity Condenser fan The condenser fan starts immediately and can be heard. Evaporator fan The evaporator fan will start after a few seconds. The... -
Page 7: Electronic Controller
SERENE SC112G Electronic Controller Introduction The electronic controller is visible through a cut-out in the front panel. It uses temperature probes and a door switch to collect data and runs the chiller accordingly. The electronic controller can be manually switched between ‘Normal’... -
Page 8: Normal And Energy Saving Modes
SERENE SC112G Normal and The electronic controller can be switched between two operating modes: Energy Saving ‘Normal’ mode and ‘Energy Saving’ mode. When in Normal mode, the interior lights are on and the internal temperature is regulated to the setpoint Modes setting (see page 9). -
Page 9: Temperature Setpoint
SERENE SC112G Temperature The chiller temperature setpoint is factory set at 2°C for storage of Setpoint perishable products (all shelves maintain temperatures below 5°C). The cabinet setpoint can be adjusted between 0°C and 4°C. SKOPE do not recommend that the setpoint be changed unless it is absolutely necessary, and then only by small increments at a time. -
Page 10: Maintenance
SERENE SC112G Maintenance Cleaning Many commercially available cleaning products contain solvents that may damage the plastic components of the chiller and cause them to crack. Do not use abrasive or corrosive cleaners or boiling water. CAUTION Isolate the chiller from the power supply before cleaning. -
Page 11: Troubleshooting
SERENE SC112G Troubleshooting For problems with the chiller refer to the following table. Problem Possible Cause Suggestions • Chiller not operating. • Loss of power supply. • Check mains power supply. • Interior lights not on. • Electronic controller • Switch the light on while... - Page 12 SKOPE Industries Limited NEW ZEALAND CONTACT Head Office PO Box 1091, Christchurch New Zealand Freephone: 0800 947 5673 Fax: (03) 983 3896 E-mail: enquiry@skope.co.nz Website: www.skope.co.nz AUSTRALIAN CONTACT A.B.N. 73 374 418 306 PO Box 7543, Baulkham Hills B.C. NSW 2153, Australia Freephone: 1800 121 535 Fax: 1800 121 533 E-mail: enquiry@skope.com.au...
Need help?
Do you have a question about the SC112G and is the answer not in the manual?
Questions and answers