5.
Auto Source: The default is "On", which can support auto search for signal source in
order.
-----------------------------------------------------------------------------------------------------------
Note: Surround application must set Auto Source is "Off".
6.
Wide mode: You can select which screen aspect you are using. The options are
Aspect, Full, 1:1 and 21:9.
7.
Lighting: Ambient light, choose to follow a favorite to many functions.
•
Lighting Switch: Lighting main switch, default is "Enable".
•
Remote Lighting: Mandatory control lighting by remote.
---------------------------------------------------------------------------------------------
Note: The function sku by country.
•
Lighting Style: 9 kinds of style choice. Static (Default),Shifting, Filling,
Breathing, Motion, Zoom ,Spectrum, Wave ,Starlight flashing.
•
Lighting Color: 6 kinds of manually select the lighting color. Blue (Default),
Red, Green ,Yellow , Magenta , Cyan.
•
Lighting Brightness: Control lighting brightness value ,when choose "Auto"
that LED brightness will depend on lightsense.
•
Lighting Health: When user select to Warm/ Normal/ Cool, LED brightness &
LED color R, G, B value are adjustment by setting value. When user select
to disable, Lighting will be return to previous lighting style.
8.
Hot Key Assigment: Select the function of shortcut key 1(Modes, Volume, Brightness,
Gamma, Contrast, Blue Light, Over Drive, VRB) and shortcut keys 2 (Modes, Volume,
Brightness, Gamma, Contrast, Blue Light, Over Drive, VRB).
9.
DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
10. ProxiSense: ProxiSense works on principle of transmission and reception of harmless
"infrared" signals in order to detect user-presence.
-----------------------------------------------------------------------------------------------------------
Note:
•
The ProxiSense is set to (Range 1 to Range 3), tolerance is (+/-) 20 cm and
ACM is off.
•
Three status (No signal, no cable connection and out of range) does not
support ProxiSense.
•
The ProxiSense controls the PWM to 50% (current OSD Brightness
parameter) or into the power saving state, and then press any key to restore
the PWM to the normal value.
•
Power The detection range of the Sensor is in the middle, the upper and
lower angles are ignored.
11. Rest Reminder: ProxiSense is set Range1~Range3 then Rest Reminder can be control
(Off ~ 100Mins), Rest Reminder default is Off.
-----------------------------------------------------------------------------------------------------------
Note:
•
ProxiSense must be set to Range 1 and Range 3 before the Rest Reminder
can be opened for selection (Off /20 Mins /40 Mins /60 Mins /80 Mins /100
Mins ), The default setting is Off to not remind.