Care & Maintenance - Neen Peritone Instruction Manual

Care and Maintenance
Control Unit:
• Wipe the surface after use with a damp cloth or antiseptic wipe.
• Do not use cleaning sprays or alcohol based cleaning solutions.
Battery:
• To change the battery, open the battery door on the rear of the control
unit by pressing down on the raised rib pattern just below the belt clip.
Lift the battery out of the compartment. This is very easy and can be
done by the user.
• Check periodically for any discharge from the battery.
• Remove battery completely from unit if not in use for any extended
period of time (typically one week).
• Low battery indicator of 6.9 volts shown on LCD display.
When flashing change battery for a new one.
• Preferably use a PP3 alkaline battery.
Lead Wires:
• The lead wires should be handled carefully and never stretched, as this can
cause the stimulation to function below normal standards or not at all.
• Examine lead wires before each treatment for loose connections or damage.
• Avoid twisting the lead wires.
• Wipe lead wires after use with a damp cloth or antiseptic wipe.
• Store the lead wires carefully after each use.
Self-Adhesive Electrodes:
• Check the short connectors have not become separated from the electrodes.
• Replace electrodes onto plastic film after use. If they drop onto the floor
debris will adhere to conductive gel rendering the electrodes ineffective.
Vaginal / Anal Electrodes:
• Check the connectors have not become separated from the probe.
• Before & after use always wash it in warm soapy water, rinse and dry
and carefully store.
• Never let anyone else use your electrode.
• Follow all instructions provided with the electrode.
Caution: Static electricity may damage this product.
NOTE: Only Patterson Medical or appointed distributors/importers are
approved to undertake servicing.
PERITONE Instruction Manual - GB
19