Table of Contents
Advertisement
HOW TO USE THE APPLIANCE
Further indications are given in the individual chapters and in the user instructions.
Open the door
How to fill
the detergent dispenser
Check the rinse aid level
Check the
salt level
Load the racks
Select a programme
Select the
required options
Turn on the tap
water tap, then close
the door to start the
programme
Wash cycle
Switch off the appliance
Turn off
the water tap, unload the
dishes from the racks
Press the On/Off button.
Large compartment A
Small compartment B
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D.
Electrical indicator light on control
panel
(if present).
Refer to the dishwasher loading instructions.
Press the
button until the desired programme lights up.
If necessary (where present). The corresponding indicator light
illuminates/the display shows the relevant information.
"Cancel"
• Open the door, press
indicator lights 4 + 5 (marked by
"end" on the control panel)
illuminate.
• Close the door, after about 1
min. the cycle ends.
At the end of the programme the dishwasher emits a brief audible signal.
Indicator lights 4 + 5 (marked by "end" on the control panel) illuminate.
Open the door and press the On/Off button.
All indicator lights switch off.
Warning: be careful opening the door, as steam will escape!
Empty the dishwasher starting from the bottom rack.
D
GB
F
A
"Change programme in
progress"
until the
• Open the door.
• Select another programme and
close the door in order to start
the new cycle. End-of-cycle.
- Only open the door if necessary
(Warning: steam may escape).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from the point where it
was interrupted.
NL
GB
C
B
D
Advertisement
Table of Contents
