Advertisement
Quick Links
ETP05N • ETP10N
Submersible Trash Pump
Instructions for Operation • Safety • Warranty
This submersible trash pump handles sand, solids, leaves, algae and
other debris up to
/
" x 1" in size. Ideal for waterfalls where algae and
3
8
leaves are a problem, recirculating systems where solids removal is
needed, dewatering applications where sand and sludge are being
pumped, or any other dirty or clean water application where a high
quality, continuous duty pump is needed. Pump includes a 2" FPT
discharge, 115v motor, 20' power cord and two year limited warranty.
Specifications
• Automatic overload and thermal protection with self reset
• Aluminum motor housing
• Top housings made of engineering composite with glass fiber rein-
forcement, bottom housing is made of cast iron
• Wear resistant TPU impeller
• High precision mechanical shaft seals
ETP05N - 2" outlet, 400w, 1/2 HP, 3600 GPH, 20' cable
ETP10N - 2" outlet, 750w, 1 HP, 5700 GPH, 20' cable
ETP10N
ETP05N
1
Advertisement
Related Manuals for EasyPro ETP05N
Summary of Contents for EasyPro ETP05N
- Page 1 ETP05N • ETP10N Submersible Trash Pump Instructions for Operation • Safety • Warranty This submersible trash pump handles sand, solids, leaves, algae and other debris up to " x 1" in size. Ideal for waterfalls where algae and leaves are a problem, recirculating systems where solids removal is...
- Page 2 Installation • Do not paint casing as overheating may occur • Lift only by handle - not by power cable • Do not hang water pump in water • Install on a solid flat base in upright position • Install proper outlet adapter for pipe or hose • Discharge end of pipe or hose must be above water level • Make sure that power cable plug and power outlet are away from water, water discharge pipe or hose Operation • Turn off power supply or circuit breaker before connecting power cable plug • Do not start operation with people standing near intake or outlet • Do not operate when suspended in air • Use pump only for circulation, transfer or removal of water or waste water • Do not pump oil, salt water or chemical liquids • T his pump must stay submerged entirely when operating. If used in a skimmer, the debris net must be kept clean to ensure adequate water flow to pump. Running pump low on water will cause overheating and premature failure which is not cov- ered under warranty.
- Page 3 Caution • Do not allow dry operation • Do not allow foreign objects to enter intake • In case of power outage, turn off power switch to avoid damage when power resumes • If excessive vibration occurs turn off power immediately Protection System The motor has a built in protection system which stops the pump when overheating occurs, due to excessive load. Load could be caused by clogging at inlet or outlet and when a fluctuation in the power supply occurs. Water Level • Never operate below minimum water level which is 6" above base level (about half way submerged) • Continuous operation water level is at least 14" above base level (submerged) • Operate for a maximum of thirty minutes if water level is between 6" and 14" Inspection • Always turn off power and remove power outlet plug from power outlet before performing inspection • Check regularly for drop in performance and remove any clogged material from inlet area, outlet hose and pipe...
- Page 4 EasyPro shall not be held liable for any damages caused by defective components or materials of this Product; or for loss incurred because of the interruption of service; or any consequential/incidental damages and expenses arising from the production, sale, use or misuse of this Product. Some States...