Cleaning And Servicing - HAIRCUT X-POWER TH01XP User Manual

Professional hair clippers
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12
EN
3

Cleaning and servicing

The clippers must be switched off and unplugged from the power socket
before carrying out any cleaning or servicing work.
3.1 Cleaning (see figures 5 and 6)
After using the clippers each time, clean the blades with the brush supplied
(fig. 5a).
Clean the blades thoroughly at regular intervals. Proceed as follows:
Use a cross-point screwdriver to remove the two screws holding the blades in
place (fig. 6a).
Remove the comb from the cutting head and the blades, and use the brush
provided to clean the inside of the blades (fig. 6b).*
With the knob (B) in the "release" position (fig. 4c) and the adjustment lever
(G) in its default position, put the blade back in place on the comb of the
cutting head so that the groove on the blade is positioned on the alignment
notch (fig. 6c).
Insert the 2 screws and tighten them. The blades are positioned automatically
(fig. 6d).
Lubricate the cutting blade (fig. 5b).
The clippers must be switched off and unplugged from the power socket
before fitting attachment combs.
*If necessary, use a cloth slightly dampened with water or mild liquid soap. Never use abrasive
products or solvents. The blades can be cleaned with a STERIL CLEANER 920- and 921- antibacterial
spray. Use this cleaning product only. In the case of regular use, clean the blades at least once a
day.
3.2 Servicing
3.2.1
Daily servicing
Lubricate the cutting blade once a day, by putting a drop of oil on the points
shown (fig 5b). Switch the clippers on for a few seconds after lubricating them.
18

Advertisement

Table of Contents
loading

Table of Contents