Advertisement
SafeTRAC System Information
Verifying Proper System Operation
You can verify your SafeTRAC system is installed and operating proper y by verifying that:
•
When the vehicle ignition is turned on, the system beeps once and illuminates the green power
indicator.
•
During vehicle operation, SafeTRAC sounds the warning and illuminates the RED alert LED when
the vehicle leaves its lane.
•
The warning alert sound and LED are
not signaled when the brakes are applied, or either turn
signal or the emergency flashers are on.
•
Pressing the operator mute button silences any current alert, and prevents the alert from
sounding for the next three minutes. Pressing the mute button again clears the mute, allowing
alerts to sound.
Troubleshooting
Condition
Possible Causes
Green power indicator not lit with ignition on.
12V power not connected
Green power indicator lit with ignition off.
12V power connected to unswitched power supply.
No warnings
Unit improperly calibrated.
Poor visibility conditions (glare, rain)
Too frequent warnings
Unit improperly calibrated.
Poor visibility conditions (glare, rain)
Mute button inoperative
Button not wired correctly. See Step 4.
Alerts sounded when brakes or turn signals on
Incorrect vehicle wiring. See Step 5.
Windshield Replacement
If you need to replace the windshield in a SafeTRAC-equipped vehicle, follow the procedure listed in
this section.
Do Not Cut Camera Cable
or
Discard Camera
1. Disconnect Camera Cable
Disconnect the camera cable from the camera at the Molex connector (typically hidden within the
vehicle headliner).
2. Remove Camera Module from Windshield Bracket
The camera is attached to the windshield bracket by four cable ties (shown in red below). Using a
utility knife, cut all four cable ties and remove the camera from the bracket. Discard the bracket with
the damaged windshield.
3. Contact T
akata
to Obtain a Replacement Bracket
Contact T
akata
with your vehicle information and T
akata
will either send you a new pre-attached
camera and bracket for installation on the replacement windshield OR a new bracket and cable ties,
along with instructions on how to connect the camera and bracket.
Specifications
l
Power requirements
Environmental limits
Precautions
Observe these precautions when installing SafeTRAC to reduce the risk of injury or equipment
damage:
•
Disconnect vehicle battery or power supply before installing SafeTRAC.
•
Avoid any physical interference between SafeTRAC wiring harness and processor unit and
moving vehicle components.
•
Properly insulate and/or protect any exposed wires or connections.
•
Do not install the SafeTRAC camera or processor unit in an area exposed to moisture, excessive
heat, dust, or vibration.
NOTE: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
Copyright © 2008 TK Holdings Inc. All Rights Reserved. This document may not be copied in whole or in part, nor transferred to any other media or
language without the written permission of
,
TK Holdings Inc.
Voltage: +12 VDC (11.5 to 30 VDC)
Current: 600 mA @ 12 VDC
Operating temperature: 14° to 122°F (-10° to 50°C)
590-7055
Printed in the U.S.A.
SafeTRAC
Installation Guide
8
Advertisement
