esotec Power Light Using Instructions

Using Instructions
Solar PIR „Power Light"
Customer support:
If you have problems or questions regarding this product, simply contact us!
esotec GmbH, Industriegebiet Weberschlag 9, D-92729 Weiherhammer
Monday to Friday 8 am to 12 noon and 1 pm to 4 pm.
By phone: +49 9605-92206-0
By e-mail for ordering spare parts: ersatzteil@esotec.de
By e-mail for questions about the product: technik@esotec.de
Product: Manufacturer Item No.: 102410 and 102412
Battery take-back
- Batteries must not be discarded into domestic waste.
- The consumer is legally required to return batteries
after use, e.g. to public collecting centers or to battery
distributors.
- Contaminant-containing batteries are labeled with the
sign "crossed-out trashcan" and one of the chemical
symbols. Used batteries should be disposed environ-
mentally friendly and should not be discarded into
domestic waste. Your dealer is legally required to take
back old batteries.
Rechargeable battery notes
- Rechargeable batteries should not be played with by children. Never
leave rechargeable batteries lying around; they could be swallowed
by children or pets.
- Rechargeable batteries must never be short-circuited, disassembled
or thrown into fire. This leads to a danger of explosion!
- Leaking or damaged rechargeable batteries can cause chemical
burns when they come into contact with skin. For this reason, please
make use of suitable protective gloves.
- Rechargeable batteries should only be replaced by structurally iden-
tical rechargeable batteries from the same manufacturer. Normal
batteries must not be used since these are not rechargeable.
- Make sure the rechargeable batteries are inserted with the correct
polarity.
- For long periods of time of non-use (for example, storage), remove
the inserted rechargeable batteries to avoid damages via the leaking
rechargeable batteries.
Disposal:
Dear customer,
please cooperate in avoiding waste. When you intend
to dispose of the product in future, please consider that
it contains valuable raw materials suited for recycling.
Therefore, do not dispose it of with domestic waste but
bring it to a collection point for the recycling of waste
electrical and electronic equipment.
Thank you very much for your cooperation!
1. Introduction
Dear customer, we thank you for purchasing the Solar Globelight.
With this Solar Light you have purchased a product that complies with the
latest and most up-to-date technology.
This product complies with the European and National
Standards. The relevant certificates of conformity are
deposited with the manufacturer.
To preserve this standard and in order to maintain safety
you must adhere to the use instructions!
2. Security Instructions
In the event of any problems arising or damage occur-
!
ring from not following these instructions, the warranty
is deemed cancelled. The manufacturer will not be held
responsible for any claims or damages arising from the
misuse of this product.
- For safety reasons and in order to maintain standards (CE) you are pro-
hibited from altering or changing any component in the product.
- Please follow the instructions very carefully.
- For commercial applications due care and attention must be paid to the
Health and Safety Standards in your jurisdiction.
3. Intended use
GB
The PIR-solar spotlight is suited for the illumination of courtyards, driveways,
entranceways and much more. It is designed for the year-round outdoor use.
The product is splashproof and must not be exposed to a direct water jet res-
pectively immersed in the water.
4. Function
The integrated motion detector is activated at night (responds to heat change).
If motion is detected, a 1 W high-performance-LED is switched on for approx. 35
seconds. The solar module works as a twilight sensor. The spotlight is activated
if the solar module is dark.
The solar module and the spotlight may be mounted on a pole or screwed to the
wall. The product is designed for the use in private households.
An LED display on the bottom side (next to the slide switch) shows a green or
red light when the spotlight is switched on. The green light indicates that the
battery is ready for operation, the red light indicates that the battery id exhau-
sted and that the spotlight is switched off in order to protect the battery. The
battery is charged at sunlight and a green light will be indicated as soon as the
battery is recharged.
Note: Please make sure that the solar module is installed directed to
the south and that shadows are avoided. The product cannot be used if
installed directed to the north. In winter, the solar module shall always be
NiMh
free of snow. The battery pack has to be exchanged at every two years
at the latest.
5. Assembly and activation
1. Please carefully take all parts out of the package and unpack the accesso-
ries.
2. Choose an appropriate place of installation for the spotlight and the solar
module. The spotlight and the module may be mounted on a pole or railing
or screwed to the wall.
3. Assembly of the solar module
screw
mounting
4. Installation of the LED spotlight on the wall
- Take off the back panel of the spotlight.
- Now mount the back panel with two screws and snap the spotlight back onto
the back panel.
5. Installation of the LED spotlight on a pole or rod/post
- By means of the mounting rod it is possible to mount the spotlight horizon-
tally or vertically at a pole or rod/post.
6. Now plug the connector of the solar module into the socket (protected by
rubber cap) of the spotlight. Switch on the spotlight via the slide switch
(ON). The solar spotlight is now activated.
7. The luminary head may be adjusted horizontally and vertically as required.
8. The motion switch may also be adjusted horizontally. A little exertion of force
is required for this purpose.
Note: During the winter months the duration of illumination will generally be
shorter. If the lamp should not yet start working on the first evening, please wait
for a sunny day.
polemounting
mounting holes
polemounting