Deck Mechanism Disassembly; Main Base; Clamp Assembly Disc; Plate Clamp - LG DK867 Service Manual

DECK MECHANISM DISASSEMBLY

DISC CLAMP ASSEMBLY

PLATE CLAMP

MAGNET CLAMP

CLAMP UPPER

FIG. 4-1
1. MAIN BASE (FIG. 4-1)

1-1. Clamp Assembly Disc

1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the
Holder Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise
direction and then lift up the Plate Clamp.
1-1-2. Magnet Clamp
1-1-3. Clamp Upper
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes

MAIN BASE

(Fig. A)
HOLDER
BASE MAIN

TRAY DISC

BASE MAIN
LEVER
BASE MAIN
BOTTOM SIDE VIEW
2. TRAY DISC (FIG. 4-2)
1) Insert and push a Driver in the emergency eject
hole(A) at the right side, or put the Driver on the
Lever(B) of the Gear Emergency and pull the
Lever(B) in direction of arrow so that the Tray
Disc is ejected about 15~20mm.
2) Pull the Tray Disc until it is separated from the
Base Main completely.
4-3
FIG. 4-2
LGE Internal Use Only