Remote Control Pairing - TiVo STREAM 4K User Manual

REMOTE CONTROL PAIRING

To use TiVo Stream 4K, your remote must be paired with your device. You most likely paired your remote during device setup, so if your
remote can control your TiVo Stream 4K, then you are set to go.
However, if you purchase a new remote, or if your remote stops working properly, you may need to pair it manually.
PAIR A NEW REMOTE
To pair a new remote (one that has not been used with another TiVo device), follow these
instructions.
1. Press the button on the side of your TiVo Stream 4K for three seconds to display the pairing
screen.
2. As instructed on-screen, press the TiVo button to pair.
RESET & RE-PAIR YOUR REMOTE
If your remote becomes unpaired or is behaving erratically, you can reset it and re-pair it to your device.
1. Press and hold the TIVO
seconds. Note: If you don't press the buttons exactly at the same time, you may see the activity light
flash yellow or yellow/red instead. Try again after the light stops flashing.
2. The activity indicator turn solid red and remain lit.
3. Press VOLUME DOWN three times, and then press the TiVo button
4. The activity light will flash red three times.
5. Pair your remote by following the instructions in
and POWER buttons on the remote simultaneously for approximately 3
Pair a New
REMOTE CONTROL
.
Remote.
32