Advertisement
60301011GB.fm Page 2 Friday, May 12, 2006 11:23 AM
Freezer compartment temperature adjustment
The appliance is normally factory set for optimum operation at a temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
• Press button E once to adjust the internal temperature: the digital display shows the temperature previously
set.
• Each time the button is pressed, the temperature setting is changed by 1°C: the value (between -16°C and
-24°C) blinks cyclically on the display.
• Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored,
the display stops blinking and the current internal temperature is shown on the display.
• The 6th Sense function (blue LED) is automatically activated due to door opening and when small amounts
of fresh food are placed in the freezer. The duration of the 6th Sense function varies depending on the
quantity of food loaded in the freezer and ambient temperature. When optimal operating conditions have
been restored the function deactivates automatically and no operation is required.
Note:
The digital display shows internal temperature values between +10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function switches off automatically when freezing is complete.
Alarm signals
Door open alarm
Temperature alarm
Temperature sensor
alarm
Prolonged power failure
alarm
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following the
introduction of fresh food in the freezer compartment; this temporary rise in temperature does not affect the
storage of already frozen food in any way.
Defrosting (for No Frost models no operation is required)
This appliance defrosts automatically according to usage and ambient humidity conditions.
Follow the steps detailed in "Switching on the appliance".
For not No Frost models, follow step 1-6:
1. Press the freezer on/off button D.
2. Unplug the appliance or switch off at the main
switch.
3. Fit the drain in place (see figure).
4. Follow the instructions given in the
instructions booklet.
5. Plug in the appliance once again.
6. Press the freezer on/off button D.
5019 603 01011
PRODUCT SHEET
Signal
The acoustic alarm is activated
The acoustic alarm and red LED C
are activated
The acoustic alarm is activated and
the display shows "SF"
The acoustic alarm and red LED C
are activated; the display blinks,
indicating the highest temperature
reached following the power failure
GB
D
F
NL
E
Cause
The door has been left open
Close the door
for more than 1 minute
The internal temperature is
Press button G; wait for
above -12°C
the temperature to fall
below -12°C again
Temperature sensor fault
Contact After-sales
service
Prolonged lack of power
Press button G; the
supply, causing the internal
display now indicates the
temperature to rise to very
current internal
high values at which correct
temperture
food storage cannot be
guaranteed
An illuminated dot appears on the digital display.
Follow the steps detailed in "Switching on the
appliance".
I
P
GR
S
N
Solution
DK
FIN
Advertisement
