Advertisement
5
Boot Steps
○
D
A.
Please confirm the Power cable and CT is locked into the module, and "Ext_Bus"
is connected an extension module by audio line. (If there is no extension module,
the "Ext_Bus" don't be connected.)
B.
Adjusting DIP switch and set the parameter of communication, and switch "PWR"
to OFF. And then switch "PWR" to ON after press "Wake" and "F3" buttons for 5
seconds.
C.
When power on, if "STA" will light on for 1 second and off, this mean boot
complete. If "STA" do not be lighted, please press "Boot" for 1~3 seconds, and
confirm "STA" will light on for 1 second and off. Finally, press "Wake" once,
confirm "STA" blink once to complete the boot.
D.
Connect the CT to the cable to be measured. The buckle has no directionality, but
after the buckle, you must confirm that the opening is completely closed.
○
A
Before the CT
be buckled
○
B
After the CT
be buckled
Confirm the opening is
completely closed
○
C
P7
Advertisement
