Page 1
Quick Start v1.0, July 2020 Packing List In addition to this guide, the package includes the following items: iWSN-1210X Screw Driver Resources How to search for drivers, manuals and spec Technical Support information on ICP DAS website. service@icpdas.com For Mobile Web www.icpdas.com...
Page 2
Warning ICP DAS assumes no liability for any damage resulting from the use of this product. ICP DAS reserves the right to change this manual at any time without notice. The information furnished by ICP DAS is believed to be accurate and reliable.
Page 3
Pin and buttons Switch Instructions Power on Power off Name Instructions +10 ~ +30 VDC Ground Split-core CT pin,no directionality,support measuring and charging function Extension bus Instructions Empty or connect Ext_Bus extension module Button Instructions Wake Manual wake up Reserved...
LED indicators The module provides one LED indicator. The table below will show the LED status. Indicators Status Instructions 500ms Illegal Node ID, please set the Node ID Blink to 1~31, and then power on. continuous Component status is abnormal. 1.
Page 7
Boot Steps ○ ○ ○ ○ Please confirm the Power cable and CT is locked into the module, and “Ext_Bus” is connected an extension module by audio line. (If there is no extension module, the “Ext_Bus” don’t be connected.) Adjusting DIP switch and set the parameter of communication, and switch “PWR” to OFF.
CT or equipment connected in the secondary circuit. 2. The external CT’s are fragile, please handle with care. 3. The current input of iWSN-1210X only supports CT sold by ICPDAS. 4. To install CT’s correctly, please ensure the CT lines sequences is right before clip the CT’s onto the power cable of the monitoring equipment.