Advertisement
Quick Links
Advertisement
Summary of Contents for Caldwell AR-500 STEEL SPINNER
- Page 1 Product # 758995 Instruction # 1048736 Revision A...
- Page 2 LOCATION FOR SHOOTING YOUR MAGNUM RIFLE SWINGER: Be sure you have a safe backstop, such as a hill or berm of soft earth. Be sure the area beyond and beside the target is safe and clear. Place the swinger directly onto soft ground. Do not place the swinger on concrete, TARGET asphalt or solid rock.
-
Page 3: Assembly Steps
ASSEMBLY INSTRUCTIONS: Thank you for purchasing a Caldwell Magnum Rifle Swinger. Assembly of this product is very easy and requires only a 16mm and 17mm wrench. The product should be assembled as shown. (See exploded view on next page) ASSEMBLY STEPS: 1. - Page 4 Washers and Nuts Elbow Target Centering Tubes Target Mounting Block Target Plate Stake Bracket Stake Close up of Center Bar section Washers and Nuts Target Centering Tubes Target Bolts Mounting Block Target Plate...
- Page 5 Close up of Stakes Replacing bars with common 1/2” Re-bar Elbow Target Centering Tubes REPLACEABLE LEGS: The frame of this target is made of 5 solid steel bars. While these bars are designed to resist damage from bullet fragments, a direct bullet impact could damage the bar.
-
Page 6: Usage Instructions
USAGE INSTRUCTIONS: The Caldwell Magnum Rifle Swinger is made of Certified AR500 Through- Hardened Target Steel. This steel is extremely durable and is designed to hold up to years of use. The Molded Parts are made of Ballistic Polymer to allow bullets to pass directly through with only minimal damage. - Page 7 • Lead and copper jacketed bullets are recommended. Solid copper or non-expanding bullets will accelerate wear on the Target. (No Armor Piercing or Incendiary bullets should be used) • The maximum IMPACT velocity of the bullet should be below 2900 feet per second.