NPD-4
Troubleshooting — BB
Phone is totally dead
Phone is dead
Phone current is zero
or too high?
No
Phone current is
< 30 mA
No
Phone current is
<= 35 mA
Yes
Is phone in local
mode?
Yes
OK restart
Page 28
Yes
Is phone flash
Yes
programming OK?
No
Check BSI line X110,
R202, R203, C230.
No
Are they OK?
Nokia Corporation
CCS Technical Documentation
-If current is zero, check X110 solder and
VBATT lines.
-If current is too high, check for shorts.
-Make sure all BB regulators are at their
respective voltage levels (e.g., VANA, VIO,
VCRE(DC-DC), VFlash1, and VR3). See
phone's top view diagram for test points.
-Make sure System Clk is 19.2MHz and
Sleep Clk is 32KHz.
-Make sure PURX and SleepX signals are
high (1.8V).
No
Yes
No
Confidential
Yes
Change UEM
Repair
Issue 1 02/2003