Tn Tx If Agc Cell Po (0) [Or (1), (2), (3), Or (4)] - Nokia NPD-4 Series Technical Documentation Manual

CCS Technical Documentation
If the minimum is 35 dB or greater, the phone passes. If the minimum is less than 35 dB,
then vary Q in the same manner as I using the above values, holding I constant at the
minimum value determined above, until the delta is at least 35 dB.
Troubleshooting: Check N601 (Robin), D200 (UEM), and associated components.
TN TX IF AGC Cell Po (0)
The IF gain curve is characterized by varying the TX_IF_AGC and measuring the transmit
power. This is only done once (in cell CDMA mode) since the same circuitry is used for
both cell and pcs.
The results are TX power readings in dBm of the transmitted signal corresponding to
given PDM settings of the Cell TX IF AGC.
Manual Verification:
Set the phone in local mode, then program it to Cell CDMA RX/TX mode on channel 384.
Set modulation to IS95 voice.
Set the Cell PA PDM to +218 decimal and the TX RF AGC to –512 decimal using the slid-
ers in the PDM window under the RF menu.
Change the TX_IF_AGC to the settings in the following table, and measure the TX power
levels, checking to see that they are within the specified range.
PDM for TX IF AGC
(a) +300 decimal
(b) + 150
(c) 0
Change the TX_RF_AGC PDM to +511. Leave the TX_IF_AGC at 0 and the PA_AGC at
+218. Measure the output power. Subtract this power from the power measured in (c) in
the table above. This is the RF_AGC gain delta.
Leave the PA_AGC and TX_RF_AGC values as is, then enter the values listed below for
the TX_IF_AGC. Measure the output power, then add to each the RF_AGC gain delta cal-
culated above. Check that these sums are within the listed ranges.
Issue 1 02/2003
448
504
560
[or (1), (2), (3), or (4)]
Acceptable range for output
power (in dBm)
check tuning results file for limits
Nokia Corporation
Troubleshooting — RF
Confidential
NPD-4
Page 17