D. Maintenance Limitations Maintenance limitations on the CE110 must be performed only at the LGE or its authorized agents. The user may not make any changes and/or repairs expect as specifically noted in this manual. Therefore, note that un authorized alternations or repair may affect the regulatory status of the system and may void any remaining warranty.
2. Performance 2. Performance 2.1 Product Name CE110 : GPRS Class 10 / EDGE Class 10 2.2 Supporting Standard Item Feature Comment Supporting Standard GSM850/DCS1800/PCS1900 with seamless handover Phase 2+(include AMR) SIM Toolkit : Class 1,2,3,E Frequency Range GSM850 TX : 824 - 849 MHz...
Page 28
3. Circuit Description 3.3.5 UART Interface CE110 has Three UART Drivers as follow : - UART1 : USB - UART2 : ETM, Calibration - UART3 : AT command, Fax_modem, Bluetooth UART1(USB) Resource Name Description USB_DP Data USB_DM Data USB_PWR POWER...
Page 29
3. Circuit Description 3.3.6 GPIO Map In total 22 allowable resources, CE110 is using 16 resources except 3 resources dedicated to SIM and Memory. CE110 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table 3.
Page 30
3. Circuit Description 3.3.7 Camera interface CE110 have a 8-bit parallel camera interface(NOBT Mode). This is a general parallel interface with vertical and horizontal synchronization signals.(See. Figure 12) The maximum clock is 96 MHz for 8- bit data data, or 48 MHz for 10- or 12-bit data.
Page 34
For USB BOOT <Table.5> ADC Channel Spec 3.4.5 Switch ON/OFF CE110 Power State : Defined 4cases as follow - Power-ON : mobile is powered by main battery or backup battery. - Power-OFF : mobile isn’t any battery. - Switch-ON : mobile is powered and waken up from switch-off state.
Need help?
Do you have a question about the CE110 and is the answer not in the manual?
Questions and answers