Table of Contents
Advertisement
Introduction
This manual describes the RFJ-2TX Floor Jack, which safely raises Vehicles up to 2 Tons.
More information about the full line of Ranger Products is available at rangerproducts.com.
This manual is mandatory reading for all users
up, operates, maintains, or repairs it.
Keep this manual on or near the equipment so that anyone who uses them can read it.
Technical support is available by calling Ranger Products at (800) 253-2363.
Shipping Information
Your equipment was carefully checked before shipping. Nevertheless, you should thoroughly inspect
the shipment
When you sign the bill of lading, it tells the carrier that the items on the invoice were received in good
Do not sign the bill of lading until after you have inspected the shipment.
condition.
items listed on the bill of lading are missing or damaged, do not accept the shipment until the carrier
makes a notation on the bill of lading that lists the missing or damaged goods.
If you discover missing or damaged goods
lading, notify the carrier at once and request the carrier to make an inspection. If the carrier will not
make an inspection, prepare a signed statement to the effect that you have notified the carrier (on a
specific date) and that the carrier has failed to comply with your request.
It is difficult to collect for loss or damage after you have given the carrier a signed bill of lading. If this
happens to you, file a claim with the carrier promptly. Support your claim with copies of the bill of
lading, freight bill, invoice, and photographs, if available. Our willingness to assist in helping you
process your claim does not make us responsible for collection of claims or replacement of lost or
damaged materials.
Safety Considerations
Read this manual carefully before using your new product.
until you are familiar with all operating instructions and warnings. Do not allow anyone else to use the
product until they are also familiar with all operating instructions and warnings.
Safety Information
Please note the following:
•
The product is a Floor Jack;
•
The product must only be used on hard and flat surfaces.
Never
•
•
Always position the Floor Jack under the factory-recommended Lifting Points of the Vehicle.
•
Make sure to center the Saddle under the load
in Floor Jack instability and possible loss of load, which is danger to anyone near the Vehicle.
2-Ton Long-Reach Floor Jack
before
you sign to acknowledge that you received it.
Use it only for its intended purpose.
exceed the rated capacity. Overloading can cause damage to or failure of the Floor Jack.
of the RFJ-2TX, including anyone who sets
after
you receive the shipment and have signed the bill of
before
lifting the Vehicle; failure to do so can result
3
If any of the
Do not use the product
P/N 5900387 — Rev. B2 — May 2020
Advertisement
Table of Contents
