Find Breaks In The Loop Wire - Flymo EasiLife GO Operator's Manual

Symptoms Cause
Uneven mowing re- The product operates for a small number of
sults. hours per day.
For the shape of the work area it is necessa-
ry to adjust the settings for
to cover all parts of the work area.
The work area is too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Collection of grass by the blade disc or
around the motor shaft.
The battery state of To prevent to become blocked in a small
charge is high, but area, the product follows the guide wire to
the product goes the charging station.
back to the charging
station.

6.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such as when
gardening with a shovel. In countries with ground frost,
also sharp stones that move in the ground can damage
the wire. Breaks can also occur due to the wire being
stretched excessively during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Damage to the insulation may
not cause disruptions until several weeks or months
later. To avoid this, always select the maximum cutting
height the first weeks after installation and then lower
the height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead to
disruptions several weeks after the splice was done. A
faulty splice can, for example, be the result of the
coupler not being pressed together hard enough with a
pair of pliers, or that a coupler of lower quality than the
original coupler has been used. Please first check all
known splices before further troubleshooting is done.
A wire break can be located by gradually halving the
distance of the loop where the break may have occurred
until there is only a very short section of the wire left.
The following method does not work if
activated. Make sure first that
ECO mode on page 22 .
off. Refer to
38 - Troubleshooting
Lawn Coverage
ECO mode is
ECO mode is switched
Action
Increase the cutting time. Refer to
estimate of the necessary operating time on
page 20 .
Change the settings of the areas where the
product starts to cut and how often. Refer to
Lawn Coverage and PassageSense on page
21 .
Decrease the size of the work area or extend
the schedule. Refer to
the necessary operating time on page 20 .
Replace all the blades. Refer to
blades on page 28 .
Increase the cutting height and then lower it
when the grass is shorter.
Remove the collection of grass and clean the
Clean the product on page
product. Refer to
27 .
Usual operation for the product.
1. Check that the indicator lamp in the charging
station flashes blue, which indicates a break in the
boundary loop. Refer to
charging station on page 36 .
2. Check that the boundary wire connections to the
charging station are properly connected and not
damaged. Check that the indicator lamp in the
charging station is still flashing blue.
Make an
Make an estimate of
Replace the
Indicator lamp in the
1622 - 001 - 03.03.2021