Advertisement
Quick Links
Advertisement
Related Manuals for Magikist iCoin CP990
Summary of Contents for Magikist iCoin CP990
- Page 1 iCoin Electronic Multi-Coin Acceptor Model CP990 Model CP890 Instruction Manual v 1.0...
- Page 2 This page intentional left blank...
-
Page 3: Electrical Connection
MOUNTING Mount the iCoin to the faceplate of the meter box using the holes on the stainless steel edgemount bracket. On the CP990 the middle left mounting hole may or may not be used as it does have restricted access due to the display enclosure. - Page 4 Power Electronic Pulse Relay Pulse Red with Red with green green Timer Yellow Black Blue Purple stripe stripe Magikist 24VAC COMMON COIN COIN COIN MT580 or Hot #2 SWITCH+ SWITCH+ SWITCH– MT580U Magikist Yellow -Black...
- Page 5 CANADIAN QUARTER, LOONIE AND TOONIE SELECTION The iCoin is preprogrammed to accept any combination of Canadian quarter, $1 (loonie) and $2 (toonie) coins. Once the iCoin is powered up, the display shows which coins the iCoin is activated to accept. For example, if the indicator lights for Cdn-$0.25 and Cdn-$1 are lit as in figure 4.1, then the iCoin will accept both the Canadian quarter...
- Page 6 TOKEN SETUP The iCoin can be easily programmed to accept up to 3 different tokens of your choice. Ensure that you have selected good quality tokens and that other operators in your area are not using a similar size token of the same alloy. While Press to Select the iCoin is compatible with most...
- Page 7 inserted into the iCoin as slow as possible otherwise the learn may fail. If the token is read correctly then the iCoin will accept the token. At this point you have another ten seconds to insert the second sample token again with taking the same care to insert without pushing the token at all.
- Page 8 CONFIGURATION SETTINGS & SETUP MODE Immediately during the first 10 to 15 seconds of power up, the iCoin display will sequence through the current configuration settings. The configuration settings are divided into 3 groups: group 1 token settings, group 2 preprogrammed coin settings, and group 3 miscellaneous settings. Group 1 settings are displayed first, followed by group 2 and then group 3.
- Page 9 cycle through all the values that are available for that setting. You may change the values of multiple settings during the time you are in setup mode. To save all changes you must press the Press to Learn Selected Token (3) pushbutton. This will save the current configurations settings and the iCoin will restart with the new settings.
- Page 10 table 8.1 Group Setting Value Group 1 Token Reading 1=low, least strict * 2=medium Token Settings 4=high, most strict 8=off 1=low, least strict * Token Sizing 2=medium 4=high, most strict 8=off 1=low, least strict * Token Speed 2=medium 4=high, most strict 8=off Group 2 1=variable *...
- Page 11 CLEANING & REMOVING COIN JAMS The iCoin allows full access to the internal coin path for cleaning or to remove a coin jam that the Coin Release Mechanism was not able to remove. Screw Holding To gain access to the internal coin path you Coin must first remove the screw that holds the Coin Release...
- Page 12 APPENDIX For future reference, write down the serial# located on the bottom of the display enclosure of the iCoin. In addition, when learning tokens, record the details of each token on the following lines: SERIAL# ___________________________________ TokenA Description ____________________________________________ TokenB Description ____________________________________________ TokenC Description ____________________________________________...