1. Manuals
  2. Brands
  3. Aurora Manuals
  4. Transmitter
  5. HT Series
  6. Protocol manual

Miscellaneous; Device Firmware Update - Aurora HT Series Protocol Manual

Hide thumbs Also See for HT Series:
Table of Contents

Advertisement

status=0&faultCode=1&Invalid_state system busy

3. Miscellaneous

3.1 Device firmware update.

The HT device can be put to bootloader mode in one of the following ways:
•
Press the FUNC button when the board is powered on.
•
Issue !**WSUPDATE command via serial port. !** is !20 for TX /HTW and !30 for RX.
•
Select 'Start Update' from the device's webpage.
•
Issue the 'EnterUpdateMode' RPC command.
Once in update mode, tftp the firmware.
If a mode change for remote session was requested and that
request is still in progress, then this error -system busy- will be
returned. Please try again after some time.
HT Series Protocol Guide v1.0.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HT Series and is the answer not in the manual?

Related Manuals for Aurora HT Series

Related Content for Aurora HT Series

Table of Contents