Modena Adattare Series User Manual page 9

How to Drain Excess Water
If the sink is 1000 mm higher or more than the floor, the excess water in hoses
cannot be drained directly to the sink. It will be necessary to drain the excess water
from hoses to a bowl or bucket or suitable container that is held outside and is lower
than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be installed properly to avoid
water leaks. Ensure that the water drain hose is not kinked or crushed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose. It must
be no longer than 4 meters, otherwise the cleaning effect of the dishwasher could
be reduced.
Syphon Connection
The waste connection must be at a height less than 100 cm (maximum) from the
bottom of the dish. The water drain hose should be in a fixed condition.
Positioning the Appliance
Position the appliance in the desired location. The back should stick to the wall
behind it, and the sides to the adjacent cabinets or wall. The dishwasher is equipped
with water inlet hose and drain hose that can be positioned to the right or the left to
facilitate proper installation.
This appliance can be installed as a countertop, under counter, or built-in
configuration.
9