Advertisement
Marking point on
squeezing body cover
Marking point on
squeezing cup
5. Install the squeezing body cover
① When it is installed downwards, the marking
point on squeezing body cover shall align
with that on the squeezing cup.
②③ Make " " at the back of the protruding part
of squeezing body cover rotate towards
" " on squeezing cup in clockwise direction
and lock.
6.See the figure. Make the two juice/marc receiving
cups put at the appropriate position: one is used to
receive juice, and another is used to receive marc
(the two cups have the same overall dimension).
Rubber pad installation
1. Before the juice cup is installed, please confirm whether the rubber pad of the marc
outlet at the bottom of the juice cup is properly installed.
1
Make the rubber pad of marc outlet inserted into the rectangular slot.
Make the rubber pad of marc outlet properly inserted.
2
Notes:
The rubber pad must be properly installed, otherwise leakage
phenomenonmay occur.
Rubber pad
2
3
5
Turn on the switch (forward)
Corotation
ON
Forward: Make fruits and vegetables pushed
Stop
R
Reverse
downwards for squeezing.
Reverse: Fruits and vegetables return upwards
Press
Notes:
Please don't use wet hand operate
Reverse
Forward
switch Before put into fruits and vegetable,
don't let unit run free, Otherwise it may
damage the unit.
Make the clean fruits and vegetables (if the size of the
fruits and vegetables is larger than that of the feed in-
let, please make them cut into the blocks with proper
size) put into the feed inlet, and make the pushed in-
wards by the pushing rod.
Pushing rod
Notes: Please use fresh fruits and vegetables
to make the juice. The stale fruits and
Feed inlet
vegetables that have been stored in
refrigerator for a long time shall be used after
being immersed in cold water for over 10min.
* The kernel of fruits must be removed.
If the machine stops suddenly during operation, press
offfirstly, and then press the "reverse" button to make
the materials in the auger pushed upwards; and then
press "forward" button (repeat the process for about 3
times).
*During "reverse" of the machine, please use hands to
press the feed tube slightly (prevent loosening of the
cover).
*If the juicer still does not run after the aforesaid
operation, please disassemble the squeezing cup for
cleaning, and then try the juicer again.
*The hard materials (such as carrot) must be cut into
strips, otherwise hard materials maybe damage juicer.
Corotation
ON
After the squeezing process is completed, please
Stop
R
Reverse
press the stop switch, and pull out the power plug.
Press
Notes:
Please do not store the squeezed
Reverse
Forward
juice for a long time.
The machine is inapplicable to crush grains (motor
clamp and mechanical failure are liable to be caused).
6
Advertisement
