Advertisement
Off-line experiments
(Off-line experiments are for when you do not have a sensor connected
directly to a computer, tablet, smartphone, or NeuLog viewer).
Materials needed:
NUL-217 GSR Sensor
BAT-200 Battery
Materials needed to configure your offline experiment:
USB-200 Module or WIFI-201 module or VIEW-101 Module
USB to mini USB cable (included with the USB-200 module).
Procedure:
1.
Connect the GSR sensor directly to the left side of a charged BAT-200
module.
When ready to collect data press the "Start/Stop" button on the GSR
2.
sensor, a red light will turn on for the duration of the experiment.
3.
To change the experiment settings first connect to your chosen device
(PC, Mac, tablet, smart device) and select the "Module setup" button.
(For more information on how to change the experiment settings view
quick start procedure section for your chosen device in this document.)
After the experiment has concluded (when the "Start/Stop" button is
4.
pressed again or the data collection period ends) connect the sensor to
your chosen device. (full instructions in each device's quick start
procedure section)
5.
Open NeuLog software.
Click the "Off-line experiment" button.
6.
Click the "Load data from sensors" button.
7.
8.
Select which experimental data to upload. (5 experimental runs can be
stored at one time on the NUL-217 GSR sensor)
NEULOG GALVANIC SKIN RESPONSE LOGGER SENSOR GUIDE
Restoring sensor's factory default settings:
Procedure:
1.
Connect the USB-200 to a PC, Mac, tablet, or smart device.
2.
Connect the GSR sensor to a USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
3.
Open the NeuLog software.
Click the "Tools" icon.
4.
Click the "Restore sensor's factory defaults" on the menu.
5.
If prompted to clear the graph, click either the "Off-line either" or
6.
"On-line experiment" (whichever you are using).
Click "Clear experiment results".
7.
8.
Resume from step 4.
Included with sensor:
NeuLog NUL-217 GSR sensor guide (this document).
GSR probes attached by durable rubber-coated wires.
Two white Velcro finger connectors.
Range and
operation modes
ADC resolution
Resolution
Max sample rate
(S/sec)
Sensor specifications
Arbitrary analog
µS
units
0 to 10
0 to 65279
16 bit
10 nS
100
Advertisement
