Advertisement
Resident PC software and browser based application can be downloaded for
free at
www.neulog.com/Download/SoftwareandApplication.aspx
software user guide.
Note: Make sure not to download and install both types of software they
will conflict on the computer.
Procedure:
1.
Install the NeuLog software
2.
Connect the USB-200 module to the PC or Mac
3.
Connect the GSR sensor to the USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
4.
Open the NeuLog software.
5.
Once a GSR sensor logo appears on the left side of the screen the
probe has been automatically identified and you can begin
experimentation.
If the GSR sensor is not automatically identified then click the "Search
6.
for sensors" icon to find the sensor.
Click on the "On-line experiment" button; this will open a graph
7.
below.
Click on the "Module setup" button located on the GSR sensor icon in
8.
the module window to change the sensor settings if need be.
9.
Click on the "experiment set up" button to change the experiment
settings if need be (experiment duration for example).
10. The GSR sensor will give a live reading in the box to the left of the
screen while plugged in.
11. To run an experiment and collect data click "Run experiment".
12. To end data collection early, click "Stop experiment".
NEULOG GALVANIC SKIN RESPONSE LOGGER SENSOR GUIDE
Tablet, smart phone device
as well as a full
Materials needed:
NUL-217 GSR Sensor
WIFI-201 WiFi module
BAT-200 Battery
Your GSR sensor needs to be connected to a WIFI-201 module. The WIFI-
201 module will create a closed NeuLog WiFi network which will stream
the NeuLog data to a device of your choosing. Once your device is
wirelessly connected to the NeuLog network you can run experiments and
collect data through a browser of your choosing.
Procedure:
1.
Connect the GSR sensor directly to the left side WIFI-201 (no wires
required).
2.
Connect a BAT-200 module to the right side of the WIFI-201 module.
3.
Although not required, we recommend plugging the BAT-200 to an
outlet using a USB to mini USB charger (such as a typical cell phone
charger). The WIFI-201 module will run for 15-75 minutes (depending
on the sensor) without being plugged in.
4.
The WIFI-201 can be powered directly using a mini to USB cord and
plugging it into your computer or a wall charger. Please note this
function is only available on WIFI-201 units with the USB icon on the
cover.
5.
For further WIFI-201 instructions or the WIFI-201 quick start guide
please visit:
www.neulog.com/Download/SoftwareandApplication.aspx
6.
The WIFI-201 indicator lights will flash; take no action until the LED
to the far left turns blue; this can take up to one minute.
Advertisement
