Table of Contents
Advertisement
37
9
Image is too small
or too large
10
Image has slanted
sides
11
Image is reversed
Problems with the Projector
#
Condition
1
The projector stops responding
to all controls
•
Adjust the zoom lever on the top of the projector.
•
Move the projector closer to or further from the
screen.
•
Press "MENU" on the control panel or remote
control. Go to "Display settings" > "Aspect Ratio"
and try different settings.
•
If possible, reposition the projector so that it is
centered on the screen and below the bottom of the
screen.
•
Perform keystone correction (if available).
•
Press "MENU" on the control panel or remote
control to open the OSD menu. Go to "Keystone" to
make adjustments.
•
Select "Default Adjustment" > "Projector
Installation" on the OSD and adjust the projection
direction.
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
Solution
Advertisement
Table of Contents
