Advertisement
I
NSTALLATION
COLLAR
O-RING
NOZZLE
Check nozzle for
proper assembly
BET
of o-ring and lock
collar as shown.
With the nozzle and
nozzle mount arrows
pointing toward each
other, align the nozzle
tabs to the mount, insert
and twist to the right
until it locks into place.
NOTE SPARE NOZZLE INCLUDED
Place a towel under
the toilet tank water
line to catch any water
that drips down during
removal. Turn off the
water spigot, then
flush the toilet and
hold the handle down
to drain out as much
water as possible.
WATER
SPIGOT
TOWEL
Connect the included
braided hose from the
t-valve outlet port to
the bidet inlet port.
Orient the position of
the t-valve as desired.
Carefully tighten
all fittings, but do
not over tighten.
Usually 1/8 to 1/4
turn past hand
snug is enough.
MAINTENANCE
The spray nozzle will self clean each time the control
knob is rotated into the CLEAN position. If a more
thorough cleaning is required, remove the nozzle by
rotating it to the left to unlock it from the mount.
1
MOUNT
NOZZLE
3
FLUSH & HOLD
5
BIDET
INLET
BRAIDED
T-VALVE
HOSE
OUTLET
Certain water conditions with high mineral
content may cause the nozzle orifices to
clog over time. Soak in vinegar or descaler
then use a soft brush to remove deposits.
Remove the toilet seat
bolts and slide the bidet
underneath the seat
mounts while positioning
the bidet mounts to align
with the same bolt holes.
Note how the bidet mounts
can be rotated as required to
achieve the proper fit. Once
in position, reinstall the seat
bolts and snug down.
DO NOT OVERTIGHTEN MOUNT BOLTS
Disconnect the toilet water
line at the tank filler valve
inlet. Be prepared for a small
amount of water to run out
from the tank filler valve
upon removal. Connect the
included t-valve and washer
to the filler valve inlet and
reattach the water line to it.
FILLER VALVE INLET
WASHER
T-VALVE
HAND SNUG ONLY - DO NOT WRENCH TIGHTEN YET
O
PERATION
Turn the water spigot and t-valve on SLOWLY to check
for leaks. Then place your right hand in front of the
spray nozzle to catch the spray and rotate the control
knob either way with your left hand. Note how the clean
and spray volume relates to the position of the knob.
NOZZLE ANGLE
CLEAN & SPRAY VOLUME
(TURN EITHER DIRECTION)
NOTE: Turn off the t-valve when not in use for
extended periods as a precaution against leaks ! ! !
2
BOLTS
SEAT
NUT
4
WATER LINE
Advertisement
