Table of Contents
Advertisement
4-6. Hard Disk Connectors: IDE1/IDE2
This mainboard has a 32-bit Enhanced PCI IDE Controller that
provides PIO Mode 0~4, Bus Master, and Ultra DMA / 33, Ultra DMA /
66,Ultra DMA / 100,Ultra DMA / 133 (Optional) functionality. It has
two HDD connectors IDE1 (primary) and IDE2 (secondary).
• IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can
connect a Master and a Slave drive. You must configure the second
hard drive on IDE1 to Slave mode by setting the jumper accordingly.
• IDE2 (Secondary IDE Connector)
The IDE2 controller can also support a Master and a Slave drive. The
configuration is similar to IDE1. The second drive on this controller
must be set to slave mode.
4-7. Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector (FDC)
that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
This connector supports the provided floppy drive ribbon cables.
4-8. 5V/5VSB Selection for KB:
JKBV1(Optional)
JKBV1
1
1-2 Closed
1
2-3 Closed
Assignment
3
5V
3
5V SB
Advertisement
Table of Contents
