Intertec Data Systems ExVENT 30 Series Operating Instructions Manual

Advertisement

Quick Links

Operating Instructions
Motor ExVENT 30xx
COM141824651Ien-2 • 03/12/2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ExVENT 30 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Intertec Data Systems ExVENT 30 Series

  • Page 1 Operating Instructions Motor ExVENT 30xx COM141824651Ien-2 • 03/12/2019...
  • Page 2 www.intertec.info Table of contents 1 Use ...................................  3 2 Explanation of symbols for warnings and signal words .................. 3 3 Safety information .............................. 3 4 Technical Data ................................  3 5 Installation................................ 4 6 Connection................................ 5 7 Commissioning...............................  5 8 Troubleshooting .............................. 5 9 Directions for use ..............................
  • Page 3 www.intertec.info Operating Instructions Motor ExVENT 30xx NOTICE ExVENT 30xx electro motors are manufactured accord- ing to Directive 2014/34/EU and serve as drives for fans, NOTE pumps, gear units or other devices. ExVENT 30xx is ap- It is essential to pay attention to this safety advice as you proved for Ex zone 1 of equipment category G in tem- may otherwise incur material damage.
  • Page 4 www.intertec.info Operating Instructions Motor ExVENT 30xx ExVENT 30xx ..without fan blade INFO You will find the precise technical data for your in- strument on the label. Type Ø Blade Bracket Illustration 2: ExVent 30xx 2D front view Rated output Rated voltage/Operating voltage Illustration 1: Label Motor ExVENT Air direction...
  • Page 5 www.intertec.info Operating Instructions Motor ExVENT 30xx If the electric motor was installed according to the guidelines specified under section Installation [}Page  4] and section Connection [}Page  5] and it is guaranteed that no foreign bodies can reach the rotating compon- ents, then the electric motor can be switched on.
  • Page 6 www.intertec.info Operating Instructions Motor ExVENT 30xx Disassembly may only be carried out by a trained per- Fault: Remedial action: son. Blocked fan blade over- Device must be replaced heats the motor – thermal safety fuse is DANGER triggered Auxiliary fan blocked Use spacers to create space Risk of fatal injury from electric current! Temperature...
  • Page 7 www.intertec.info Operating Instructions Motor ExVENT 30xx complies with the provisions of the following directives The legally defined warranties and warranty periods of 2014/34/EU (ATEX), 2014/30/EU (EMC), 2011/65/EU 24 months are applicable to our scope of supply and ser- (RoHS), 2012/19/EU (WEEE) complies with the following vices.

Table of Contents