Biostar M7MKE User Manual page 75

Chapter 4
A number of causes
could be behind this.
Incorrect information
entered into the
configuration (setup)
program.
No power to monitor.
Monitor not connected
to computer.
%)*#
Use a file by file backup
instead of an image
backup to backup the hard
disk.
%)*#
Check the configuration
program. Replace any
incorrect information.
%)*#
Trouble shooting
Back up any salvageable
data. Then low level
format, partition, and high
level format the hard
drive. Re-install all saved
data when completed.
Review system's
equipment . Make sure
correct information is in
setup.
Check the power
connectors to monitor and
to system. Make sure
monitor is connected to
display card.
See instructions above.