Table of Contents
Advertisement
Chapter 4
A number of causes
could be behind this.
Incorrect information
entered into the
configuration (setup)
program.
No power to monitor.
Monitor not connected
to computer.
$()*
Use a file by file backup
instead of an image
backup to backup the hard
disk.
$()*
Check the configuration
program. Replace any
incorrect information.
$()*
Trouble shooting
Back up any salvageable
data. Then low level
format, partition, and high
level format the hard
drive. Re-install all saved
data when completed.
Review system's
equipment . Make sure
correct information is in
setup.
Check the power
connectors to monitor and
to system. Make sure
monitor is connected to
display card.
See instructions above.
Advertisement
Table of Contents
