Activation; Heating / Cooling Operation Mode Setting; Stand By; Temperature Selection - Aquarea AIR 200 Installation Manual

USE
6.5

Activation

To activate the device
key Operation
Press the mode/off key
Select one of the 4 operation speeds by pressing the relative mode/off key. When heating, the
symbols remain switched on when the set point is higher than the environment temperature; they are
switched off when the set point is lower. When cooling, the symbols are switched on when the set
point is lower than the environment temperature; they are switched off when the set point is higher.
6.6

Heating / cooling operation mode setting

key Operation
Keep Heating / Cooling pressed down for about 2 seconds to switch the operation
mode between heating and cooling, shown through the 2 active heating or active
cooling symbols which appear.
Flashing of one of the 2 o symbols indicates that the
water temperature (hot or cold) is not satisfactory, and
6.7

Stand By

key Operation
Keep the mode/off key pressed for about 2 seconds. The lack of any light indicators
from the display indicates "standby" status (no function).
6.8

Temperature selection

key Operation
Set the desired temperature value, shown on the 2 digits of the display, with the aid of
the two increase and decrease keys.
The adjustment range goes from 15 to 30°C, with 1°C
resolution, but over range values of 5°C and 40°C are
also consented.
Set these values only for brief periods, then adjust the
6.9

Fan speed adjustment

key Operation
At each pressing of the mode/off key there is a corresponding change in fan speed
between supersilent, minimum, medium and maximum.
Activation of the function is indicated by the relative symbol appearing on the display.
The supersilent speed causes strong de-humidification
in cooling and a radiating-only function (with fan off and
solenoid valve activated) in heating.
By setting maximum speed, the maximum distributable
power is immediately obtained both in heating as well as
cooling.
24
the ventilator is stopped until the temperature reaches an
adequate value to satisfy the request.
selection on an intermediate value.
The command is very precise; reach the desired value
and wait for the command to carry out the adjustment
based on the effective environment temperature detected.
Once the desired environment temperature is reached, it
is advised to select one of the other 3 operation modes to
obtain the best thermal and acoustic comfort.
U I S
Display
Off
Display
Display
Off
Display
Display