LevelOne WAC-2003 Quick Installation Manual page 5

Available languages

2. Equipment Installation

■ It is installed in the rack (For WAC-2003)

Install the Wireless LAN Controller on a 19-inch standard rack, and the installation steps are as

follows:

1. Check the grounding and stability of the rack;

2. Install the two L-shaped brackets in the accessories on both sides of the Controller panel,

and fix them with the screws in the accessories;

3. Place the Controller in the appropriate location of the rack, and support itusing a tray;

4. Secure the L-shaped brackets on the guide slots fixed at both ends of the rack, to ensure that

the Controller can be mounted on the rack in astable, horizontal manner;

5. Use a power cord to connect the Controller power connector with the powersocket.

■ Installed on the working table

Install the Controller on a working table, and the installation steps are as follows:

1. Place the Controller with its bottom up on a sufficiently large, stable and properly-grounded

working table;

2. Remove the adhesive protective paper from the foot pad, and stick the 4 pads in the 4round

slots at the bottom of the casing respectively;

3. Flip over the Controller, and place it on the working tablestably;

4. Use a power cord to connect the Controller power connector with the power socket.

5. The Controller uses 100-240V, 50/60Hz AC, and make sure that both power supply and

grounding are normal before power on.

6. After power on, please check the Controller's power indicator (Power) is on, and if so, it indicates

that

the power supply is connected properly.

7. Do not place heavy objects on the top of the Controller.

3. Logging on to the equipment

1. Connect the RJ-45 interface cable of a Controller with a computer using a network cable.

2. Set the TCP/IP properties of the computer, see the Appendix: Setting up your computer.

3. Logging on to the equipment: Open a browser and type 192.168.1.1 in the address bar, and

then press Enter; in the pop-up login interface, enter the factory logon username "admin",

password "admin" and click OK.

- 3 -

Table of Contents