Advertisement
3. Sensors Installation
Sensors should be stick on the two sides of entrance with the stickers we support. Please make
sure they are face to face and in same height.
Note:
If receiver sensor doesn't get the signal from transmitter sensor, the red light flashes.
If receiver sensor get the signal from transmitter sensor, no red light flashes.
Tilt position can be adjusted by metal stand (purchase on selection)
Can penetrate glass door with a tilt angle of less than 30 degrees
Paste on the door frame or wall with double-sided sticker
4. Receiver Settings
Receiver is operated by two touch buttons. When there is no touch operation, the screen will
shut down after 10 seconds. Long press K1 or K2 to enter the setup menu. Or connect receiver to
computer via a USB cable and set the parameters through the client program.
1. DataTime Set
▼K1
K2▼
Set the system time, long press K1 to enter the setting option.
Long press K1 to change position, long press K2 to save and exit.
Short press K1, K2 to adjust the numerical value.
Advertisement
