Advertisement
Quick Links
1. Introduction of Sensors
2. Battery Installation
Sensors are powered by ER18505 battery.
When yellow lights keeps flashing on receiver sensor, or red lights flashing on transmitter sensor,
you should replace a new battery.
Please note the battery installation direction
Advertisement
Summary of Contents for Cablematic HPC015
- Page 1 1. Introduction of Sensors 2. Battery Installation Sensors are powered by ER18505 battery. When yellow lights keeps flashing on receiver sensor, or red lights flashing on transmitter sensor, you should replace a new battery. Please note the battery installation direction...
-
Page 2: Sensors Installation
3. Sensors Installation Sensors should be stick on the two sides of entrance with the stickers we support. Please make sure they are face to face and in same height. Note: If receiver sensor doesn’t get the signal from transmitter sensor, the red light flashes. If receiver sensor get the signal from transmitter sensor, no red light flashes. - Page 3 Set the work period, long press K1 to enter the setting option. 3. Work Period ▼K1 Long press K1 to change position, long press K2 to save and exit. K2▼ Receiver has two modes of operation: high speed, low speed. 4.
- Page 4 For further details, please check the software tool instruction. Export data via U disk Only support U disk with FAT32 file system, recommend the storage capacity not exceed 32G, use the matching converter, then insert to Micro USB port on the sensor. Enter the “cache management”...
-
Page 5: Indicator Light Status
7. Indicator Light Status 8. Common Problems Solution: 8.1 Red light on Counter terminal keeps flashing: 8.1.1. The infrared sensor counter transmitter and the counter terminal are not aligned or not at the same height Solution: Adjust the counter transmitter and terminal installation position so that both of them are at the same height and face to face.