Pando PLB-7145 Installation And User Manual page 232

( All the pictures are for your reference only, please see the actual product for detail.
Ensure proper grounding
exists before use
COLD WATER CONNECTION
Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is fastened
tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure
that the water is clear. This precaution is needed to avoid
the risk of the water inlet to be blocked and damage the
appliance.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY
OF A, B
Front
Counter
NOTE
The top of the hose
A
must be less than
1000mm.
B
Drain pipe
φ 40mm
USE SUITABLE DISHES
Do not put in items that are not heat resistant .
If you buy new dishes please make
sure that they are suitable for dishwashers.
IN ORDER TO HAVE A GOOD WASHING PERFORMANCE
PLEASE FOLLOW THE BELOW RULES:
More specific photoes and installation process are provided in the Instruction.
ADD SALT
Insert the drain hose
into a drain pipe with a
1
minimum diameter of
40mm, or let it run into
the sink, making sure
to avoid bending or
crimping it. The top of
the hose must be less
than 1000mm.
2
LEVELLING THE APPLIANCE
Once the appliance is positioned for levelling, the height of the
dishwasher may be altered via adjustment of the screwing level
of the feet. In any case,the appliance should not be inclined more
than 2 .
DO NOT PLAY WITH OR SIT ON
THE DISHWASHER
Keep children away from detergent and rinse aid, keep
children away from the open door of the dishwasher,
there could still be some detergent left inside.
Young children should be supervised to ensure that
they do not play with the appliance.
Note: This instruction is only applicable to machines
with water softener
1.Before first wash, add 1.5kg dishwasher salt and then full the salt container
with water.
2.Use only special softening salt suitable for household dishwashers.
3.Use the salt funnel to fill the salt container.
4.Fill the salt container just before starting one of the
Open
complete washing programmes to
5.After filling the container , screw the cap tightly back clockwise.
NOTE:
In case that multifunctional detergent like "3 in 1" detergent tabs are used and
a lot of spots at dishes and glasses appear, you should immediately activate
the water softener of your dishwasher by the use of regenerating dishwasher
salt.
Immediately after filling the salt into the salt container, a washing
programme should be started. Otherwise filter system, pump or other
important parts of the machine may be damaged by salty water. It is out of
warranty.
The sealing cover has to be closed in the right way, in order to prevent salt
coming out of the salt container and causes damage like rusting of
component parts. Additionally, improperly closed sealing cover can
cause damage in water softener in case detergent comes in.
)
prevent corrosion.
EN