Advertisement
b) Handle adjustment
There are 3 different positions with different functions for the Release Lever (part No.106) - see
picture 1.
Test different functions by putting the Release Lever in 3 different positions respectively. If it does
not function properly, then adjust Lock Nut (No.113) by the following process. See picture 2.
Problems
Fork not lifting up
Fork not lowering down
Slow lifting no function
Quick lifting no function
Function of Adjusting Screw (No.187) for Release Lever (see picture 1)
To fix release lever (No.106) into its three (3) positions properly by adjusting the screw, you can
adjust the operating force of the release lever. To prevent accidental touch of the Release Lever
which could cause sudden sliding down of the fork, you can tighten the Screw (No.187) in the
position I or II of the Release Lever (No.106). See picture 1.
How to release the air from the pump
See picture 3
When pushing the handle down, the fork can't be lifted instantly. Please loosen the Screw (No.130)
on the pump while pushing the handle down slowly to release the air from the pump. Then tighten
the screw.
When to add oil
See Picture 3
If the fork can't be pumped up to its rated highest position, you may have to add hydraulic oil into
the oil tank. The hydraulic fluid to be used must have a quality of ISO VG22 or equivalent. Mixing of
different fluids is prohibited!
Position III: Descending for fork
Position II: Slow lifting for fork
Position I: Quick lifting for fork
Turning direction of
Lock Nut
– (counter-clockwise)
+ (clockwise)
+ (clockwise)
– (counter-clockwise)
3
Advertisement
