Advertisement
General Information
1. Lay the shipping box down on the floor, ensuring that you have adequate space
to lay the loudspeaker down after removing it from the shipping box. Note: If your
floor is not carpeted, lay a blanket or other suitable soft fabric on the floor to prevent
damage to your loudspeakers.
2. Rotate the box so that the white product label affixed at the factory is on top and
facing up.
3. Pull the top flaps of the shipping box up, taking care not to cut yourself on the staples
used to close the box. Open the other cardboard flaps to expose the loudspeaker
still cradled in it's protective foam and inside a protective plastic bag. Remove the
foam pieces over the top of the speaker. DO NOT open box ends.
4. Remove the loudspeaker by lifting it straight up and out of the box. Due to their
weight, we recommend that two people work together to remove Models 520i and
420i.
Assembly Instructions: Special assembly instructions can be found in the last
section of this manual.
Proper Hookup: Red terminal post to positive (+) amplifier post
Most BG loudspeakers can be bi-wired or bi-amped by simply removing the gold
plated jumper to allow separate wires to be run to the low and high pass section of
your system.
Break-In Times: Typically a BG loudspeaker requires not less than 48 hours of
operation at moderate sound level before reaching its optimum sound quality. This
improvement may be rather subtle but noticeable for a trained listener.
Note: Do not play your loudspeakers excessively loud to try to accelerate this
process!
Amplifier: BG loudspeakers are extremely accurate and deliver a high degree
of detail and resolution. Therefore a good 100-150 watt per channel amplifier
or receiver will deliver adequate power for typical system and room size. Your
authorized BG dealer can recommend an amplifier best suited to your needs.
4
Unpacking Your BG Loudspeakers
Black terminal post to negative (-) amplifier post
© BG Corp 2005
Advertisement
