Cleaning And Maintenance; Technical Data - APRILIA AHC 5002 User Manual

Hide thumbs

Table Of Contents

Table of Contents

the length. Each comb leaves the hair. It is suggested to try the longest comb 10.4 on

the clipper first, then use a another comb if the desired length is shorter. For uniform

cutting, never push or force the clipper through the hair at a fast rate.

• Start by combing the hair in its natural direction, place the largest, attachment comb

onto the clipper and start by trimming the sides from the bottom upwards. Hold the

clipper lightly against the hair with teeth of the attachment comb pointing up.

• Slowly lift the clipper up and outward through the hair, cutting only a small amount

at a time. Repeat around sides and back of head.

Use blade lever

• The blade lever allows you to gradually change the closeness of your cut without

an attachment comb. When the lever is in the uppermost position, the blades will

give you the closest cut and leave the hair very short. Pushing the lever downward

gradually increases the cutting length. In its lowest position, the lever will leave the

hair approximately the same

• Always remove the plug from the outlet first. After each use, remove any hair with

the cleaning brush and spread one or two drops of oil on the blades. Use only acid-

free oil as supplied. Unscrew the blades regularly and remove all hair trimmings.

When replacing the blades make sure that they are properly adjusted. The blades

are adjusted as follows:

– Screw the blades back on the clippers, but do not turn the screws tightly yet.

– Turn the blade lever to the side downward.

– Shift the top blade until it is even (parallel) with the bottom blade and be sure that

the two blades are about 1.2mm (1/32 inch) apart.

– Now tighten screws firmly and make sure that the blades cannot shift.

• Clean the outside of the clipper with a clean soft, damp cloth. Never immerce the

device in water or other liquid.Do not place or store appliance where it can fall or be

pulled into a tub or sink.