Subscribe to Our Youtube Channel
Related Manuals for Coppernic Access
Summary of Contents for Coppernic Access
- Page 1 Access Quick Start and Regulatory Guide 200144 A00 | Non-Contractual Pictures |...
-
Page 2: What's In The Box
Access Quick Start and Regulatory Guide 200144 A00 WHAT'S IN THE BOX ? Access DEVICE HANDSTRAP EU PLUG NOTICE CABLE MICRO USB C | USB A BATTERY POWER SUPPLY TEST REPORT Page 02 | 12... -
Page 3: Product Overview
Access Quick Start and Regulatory Guide 200144 A00 PRODUCT OVERVIEW Access 2D imager led indicators receiver P3 function key P1 function key SCAN | KEY RIGHT KEY LEFT UP P2 function key SCAN | KEY LEFT DOWN volume keys +/- on | off button 5’’... - Page 4 Access Quick Start and Regulatory Guide 200144 A00 Setting up your device NANO SIM | MICRO SD cards installation Press the left and right latches at the same time and remove the battery. • Insert the Micro SD card into SD slot •...
- Page 5 Make sure that the latches are properly positioned to the left and right so that the battery door closes properly. CAUTION 1. Replace the battery only with an identical battery or with an equivalent type of battery recommended by Coppernic. 2. Please recycle used batteries in accordance with current regulations.
-
Page 6: Device Access
• Charge the BATTERY Before using the Access, please charge the battery using one of the following accessories approved by COPPERNIC. Insert the micro USB-C cable into the Access and the USB A cable into the power supply. > The Micro USB C | USB A cable is included in the device’s box. -
Page 7: Back View
At higher temperatures (e.g. approximately +37°C) the device or cradle may for small periods of time alternately enable and disable battery charging to keep the battery at acceptable temperatures. The Access and its cradle indicates when charging is disabled due to abnormal temperatures via its LED. -
Page 8: Using Your Device
Access Quick Start and Regulatory Guide 200144 A00 Using your device TURNING ON | TURNING OFF your device Power On | Press and hold for 3 seconds the ON | OFF button. Power Off | Press and hold for 2 seconds the ON | OFF button and select “Power off” in the dialog box. - Page 9 Complies with 21cfr1040.10 and 1040.11 except for deviations pursuant to laser notice no. 50, dated June 24, 2007 and IEC/EN 60825-1:2014. Scan with the imager Use the "B-Manager" application provided by Coppernic to set up the reader and the "B-Scan" application to read a • barcode.
-
Page 10: Country Roaming
Quick Start and Regulatory Guide 200144 A00 CAUTION Only use accessories tested and approved by COPPERNIC to ensure compliance with European standards. Operation of the device without regulatory approval is illegal. Wireless Device Country Approval Regulatory markings, subject to certification, are applied to the device signifying the radio(s) are approved for use in the European countries under CE coverage. -
Page 11: Laser Devices
Power Adaptor Use only an Access approved Power Adaptor with electrical ratings: Output 5VDC, min 2A, with a maximum ambient temperature of at least 45°C. Use of alternative power adaptor will invalidate any approvals given to this device and maybe dangerous. -
Page 12: Battery Safety
Ad-Hoc operation is limited to Channels 36- 64 (5150 – 5350 MHz) . Use of this band is restricted to indoor use only, any other use will make the operation of this device illegal. This device complies with Directive 2014/53/EU issued by the Commission of the European Community. Copyright 2021 COPPERNIC. All rights reserved. © Page 12 | 12...
Need help?
Do you have a question about the Access and is the answer not in the manual?
Questions and answers