Page 1
Assembly/Operations of Traveling Speed Chock ITD1260 Below is a list of parts needed to assembly a Traveling Speed Chock. Hardware is included with product Required Hardware List For Assembly: 1/4” x 3/4” Carriage Bolt Knob 1/4” Washers Push Cap 1/4” Nylok Nuts...
Page 2
Assembly Procedure: Traveling Speed Chock is reversible and can be assembled to be used on the Driver’s or Passenger’s side. Diagrams below represent product being assembled for the Driver’s side. One Side Only, Opposite of Main Tube DRIVER’S SIDE CONFIGURATION WARNING This device is intended to help control a runaway vehicle during an unexpected wire rope disconnect from loading or unloading a vehicle from a carrier deck.