Disassembly; Disassembly Flow; Amp Block - Sony SA-WCT180 Service Manual

SA-WCT180
• This set can be disassembled in the order shown below.
2-1.

DISASSEMBLY FLOW

SET

2-2. AMP BLOCK

(Page 6)
2-3. MAIN BOARD
(Page 7)
2-4. POWER BOARD
(Page 8)
2-5. AC CORD (AC1)
(Page 9)
Note: Follow the disassembly procedure in the numerical order given.
2-2. AMP BLOCK
How to install the connector
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into Insert only part way.
the interior.
connector
connector
connector connector
6
SECTION 2

DISASSEMBLY

2-6. FRONT PANEL BLOCK
(Page 10)
2-7. LOUDSPEAKER (13 cm) (SP1)
(Page 11)
NG NG
Insert at a slant.
connector
connector
1 four screws
(3.5 14 B)
1 four screws
(3.5 14 B)
2-8. GRILLE (SW) ASSY
JIG
When disassembling the unit, use the following
jig for speaker removal.
Part No. Description
J-2501-238-A JIG FOR SPEAKER REMOVAL
2 Remove the AMP block
in the direction of the
arrow.
– Rear view –
5 AMP block
(Page 11)
4 LED board cable
connector (XS5)
3 speaker cable connector
(XP8)